北检（北京）检测技术研究院

1.1 This is a fire-test-response standard.

1.2 This test method provides a means of determining the burning behavior of stacking chairs used in public occupancies by measuring specific fire-test responses when a stack of chairs is subjected to a specified flaming ignition source under well ventilated conditions.

1.3 This test method is limited to stacked chairs.

1.4 Test data are obtained describing the burning behavior following application of a specific ignition source from ignition until all burning has ceased a period of 1 h has elapsed or flashover under test conditions appears inevitable.

1.5 This test method does not provide information on the fire performance of stacked chairs under fire conditions other than those conditions specified in this test method. In particular this test method does not apply to smoldering ignition by cigarettes. See for further information.

1.6 The rate of heat release of the burning test specimen is measured by an oxygen consumption method. See for further information.

1.7 Other measurements are the production of light-obscuring smoke and the concentrations of certain toxic gas species in the combustion gases. See for further information.

1.8 The burning behavior is documented visually by photographic or video recordings.

1.9 This standard is used to measure and describe the response of materials products or assemblies to heat and flame under controlled conditions but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials products or assemblies under actual fire conditions.

1.10 Fire testing of products and materials is inherently hazardous and adequate safeguards for personnel and property shall be employed in conducting these tests. This test method may involve hazardous materials operations and equipment.

1.11 Use the SI system of units in referee decisions; see IEEE/ASTM SI-10. The units given in parentheses are for information only.

This standard does not purport to address all of the safety concerns if any associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.1 This consumer safety specification establishes testing requirements for structural integrity and performance requirements for childrenx2019;s folding chairs. It also provides requirements for labeling. The term unit or product will refer to a childx2019;s folding chair.

1.2 This specification covers a folding chair intended to be used by a child with a seat height 15 in. or less.

1.3 No product produced after the approval date of this consumer safety specification shall either by label or other means indicate compliance with this specification unless it conforms to all applicable requirements contained herein before and after all testing.

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 This standard does not purport to address all of the safety concerns if any associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.1 This consumer safety specification establishes testing requirements for structural integrity and performance requirements for childrenx2019;s folding chairs. It also provides requirements for labeling. The term unit or product will refer to a childx2019;s folding chair.

1.2 This specification covers a folding chair intended to be used by a child with a seat height 15 in. or less.

1.3 No product produced after the approval date of this consumer safety specification shall either by label or other means indicate compliance with this specification unless it conforms to all applicable requirements contained herein before and after all testing.

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 This standard does not purport to address all of the safety concerns if any associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.